GOC375768-CT-BAG-REPOST 3 - Contractor - Replace Fire Alarm System

Statement of Work/Overview:
 Replace existing Fire Alarm panel with new addressable fire alarm system.  This includes replacement of all wiring, detectors and pull stations, as well as replacement of bells with strobe & horns.  All devices must be up to date with the current NFPA, CSA, and NBC requirements including but not limited to audibility and visibility requirements. Ensure new system would be completely installed, verified, commissioned and operational prior to removal/decommissioning of old system. All newly installed fire alarm system must be tested and verified before the old system is removed/replaced. All Testing verification forms to be issued to Consultant & BGIS for review the same day. Complete review with Consultant and issue signed Performance Verification checklist before removing old system. GC to ensure after each work shift that building is fit for occupancy before leaving the site. GC to maintain Fire integrity and all Fire stopping to be included in the scope where required. All devices must be up to date with the current NFPA, CSA, and NBC requirements including but not limited to audibility and visibility requirements. Ensure compliance with all Audibility and visibility levels as indicated in the Code and NFPA, which is used during the design process to ensure the correct number of devices are installed, at the correct distance from each other.  All newly installed units must be tested & verified for sound level and visibility as part of commissioning after installation.  All Testing required should be scheduled & witnessed by Consultant, BGIS Operations and Maintenance Contractor. Contractor to issue signed Verification list as proof of compliance.  The device data sheets (shop drawings) should indicate all data points, which must be met to ensure code compliance. 
Heritage areas, including the front lobby and ceiling spaces where smoke/heat detectors are installed must be protected from work or damage per heritage requirements.  Use hand tools as required. Heritage areas which may be affected include the front lobby area where the annunciator panel is located, and the ceiling spaces where smoke/heat detectors are installed.  Devices and equipment are installed on the gypsum/plaster ceilings and walls, not in direct contact with any Heritage aspects of the building. Contractors must ensure the replacement of these units and associated wiring does not affect the stone and terrazzo features.  All Heritage materials must be protected from work. Devices and equipment currently installed in this building are installed in plaster, gypsum or block walls, with wiring which leads back to the main panel for controls.  Each of these units is either surface mounted or inset.  Each unit would be removed, similarly to how a light fixture would be removed from its mount, wiring shall be fished from its source for replacement, and the new device or unit shall be installed in place (mounts may also be replaced).  Surface conduit is not acceptable.  Fire alarm conduits should be marked with red tape or paint as required. Pre & Post construction Site Photos to be taken and work documented in detail, prior to completing work and issue as part of close out documentation to Consultant & BGIS for approval. Provide Progress site photos and issue Work Permit weekly. Performance verification forms should be signed by both GC & Consultant.
Awarded GC to provide detailed Schedule & confirm Fire watch scheduling including number of escorts required per day & for how long with BGIS & Commissionaires. GC to contact mfriel@commissionaires-ottawa.on.ca for all escort request directly and schedule changes while copying BGIS PM. Due to nature of site as a Federal government building, allowances/sufficient notice (minimum one week) must be made for scheduling. PHASING OF WORK WILL BE REQUIRED TO MINIMISE IMPACT TO TENANTS. Awarded