GOC374587 - CS - Pressure Piping Inventory and Testing

Consultant scope to include the retrieval or development of relevant design and manufacturing data. To conduct and identify a complete inventory of vessels and components, including nameplate data, and define system pressure boundaries.   Establish an adequate database on all vessels, relief devices and associated components.  Inspection should include all accessible components and welds for indications of potential failure or degradation such as cracks, flaws, corrosion, deteriorating pipe supports, pipe flange bolting, brackets, or other physical deterioration. The results of all visual inspections from the initial inspection must be documented and summarized in the documentation and engineering analysis results        section of the report.
• Conduct an engineering design and operability evaluation using applicable codes and standards.   Identify Design and operating conditions, including service fluid, operating  temperature, and maximum allowable working pressure (MAWP).   Perform a life cycle analysis of the system.    This may include recalculation of vessel wall thickness, design pressure, and re-evaluation of service conditions, material thickness, corrosion allowance, efficiency of weld joints.
• Identify any recommendations from the field verification that may indicate further testing, engineering analysis, component repair, or component replacement are required.   Complete documentation of all findings is required for baseline documentation. A detailed written report with testing methodology followed (hydrostatic, pneumatic) including any destructive and non-destructive evaluations that may have been performed.   Identify any  deficiencies and provide recommendations with  conclusions. Pressure Piping Inventory and Testing